25/07/2009 Acheivements

Electric Go Kart

• Went to quad shop.
• Purchased sprocket 14teeth (same as motor) that will go perfectly over 17mm axle.
• Looked at disk brakes and hydraulic brakes (too expensive !)
• Yes - they have tie rod ends. But too large ! Just tighten those I have.
• Disassembled front end, ready to make into electric Kart.
• Measured king pin bolt - need 10mm shoulder. Maybe from Kart shop itself.
• Spoke to Poppy about steel supply. He has 2m of 20mm precision rod. We should go to steel shop together, to see what they have.
• Analysed the brake required. Purchased this brake on eBay.